Sane use of test_expect_failure

Originally, test_expect_failure was designed to be the opposite
of test_expect_success, but this was a bad decision.  Most tests
run a series of commands that leads to the single command that
needs to be tested, like this:

    test_expect_{success,failure} 'test title' '
	setup1 &&
        setup2 &&
        setup3 &&
        what is to be tested
    '

And expecting a failure exit from the whole sequence misses the
point of writing tests.  Your setup$N that are supposed to
succeed may have failed without even reaching what you are
trying to test.  The only valid use of test_expect_failure is to
check a trivial single command that is expected to fail, which
is a minority in tests of Porcelain-ish commands.

This large-ish patch rewrites all uses of test_expect_failure to
use test_expect_success and rewrites the condition of what is
tested, like this:

    test_expect_success 'test title' '
	setup1 &&
        setup2 &&
        setup3 &&
        ! this command should fail
    '

test_expect_failure is redefined to serve as a reminder that
that test *should* succeed but due to a known breakage in git it
currently does not pass.  So if git-foo command should create a
file 'bar' but you discovered a bug that it doesn't, you can
write a test like this:

    test_expect_failure 'git-foo should create bar' '
        rm -f bar &&
        git foo &&
        test -f bar
    '

This construct acts similar to test_expect_success, but instead
of reporting "ok/FAIL" like test_expect_success does, the
outcome is reported as "FIXED/still broken".

Signed-off-by: Junio C Hamano <gitster@pobox.com>

1 files changed, 4 insertions, 4 deletions

diff --git a/t/t5401-update-hooks.sh b/t/t5401-update-hooks.sh
index 9734fc542..9a1202424 100755
--- a/t/t5401-update-hooks.sh
+++ b/t/t5401-update-hooks.sh
@@ -60,8 +60,8 @@ echo STDERR post-update >&2
 EOF
 chmod u+x victim/.git/hooks/post-update
 
-test_expect_failure push '
-	git-send-pack --force ./victim/.git master tofail >send.out 2>send.err
+test_expect_success push '
+    ! git-send-pack --force ./victim/.git master tofail >send.out 2>send.err
 '
 
 test_expect_success 'updated as expected' '
@@ -112,8 +112,8 @@ test_expect_success 'all *-receive hook args are empty' '
 	! test -s victim/.git/post-receive.args
 '
 
-test_expect_failure 'send-pack produced no output' '
-	test -s send.out
+test_expect_success 'send-pack produced no output' '
+	! test -s send.out
 '
 
 cat <<EOF >expect