blob: f5200712718d20849e2bbdade65d70218df59feb (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
|
#
# Qualcomm network device configuration
#
config NET_VENDOR_QUALCOMM
bool "Qualcomm devices"
default y
---help---
If you have a network (Ethernet) card belonging to this class, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about Qualcomm cards. If you say Y, you will be asked
for your specific card in the following questions.
if NET_VENDOR_QUALCOMM
config QCA7000
tristate
help
This enables support for the Qualcomm Atheros QCA7000.
config QCA7000_SPI
tristate "Qualcomm Atheros QCA7000 SPI support"
select QCA7000
depends on SPI_MASTER && OF
---help---
This SPI protocol driver supports the Qualcomm Atheros QCA7000.
To compile this driver as a module, choose M here. The module
will be called qcaspi.
config QCA7000_UART
tristate "Qualcomm Atheros QCA7000 UART support"
select QCA7000
depends on SERIAL_DEV_BUS && OF
---help---
This UART protocol driver supports the Qualcomm Atheros QCA7000.
Currently the driver assumes these device UART settings:
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
To compile this driver as a module, choose M here. The module
will be called qcauart.
config QCOM_EMAC
tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support"
depends on HAS_DMA && HAS_IOMEM
select CRC32
select PHYLIB
---help---
This driver supports the Qualcomm Technologies, Inc. Gigabit
Ethernet Media Access Controller (EMAC). The controller
supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s,
full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for
low power, Receive-Side Scaling (RSS), and IEEE 1588-2008
Precision Clock Synchronization Protocol.
source "drivers/net/ethernet/qualcomm/rmnet/Kconfig"
endif # NET_VENDOR_QUALCOMM
|
